
We built this 1000mm, 900W carbon fiber heat lamp for the places where heat has to be precise—and fast. Think production lines that can’t afford to wait around. It packs a serious punch into a small footprint, so it fits right in where space is tight and the work is demanding. Here’s the thing about the specs: that 1000mm length and 900W rating were chosen to give you high power density right where you need it. You get the heat flux required for spot heating or curing without over-engineering the whole setup. And it runs on standard industrial voltage, so it plays nice with the control panels and wiring you already have. The heart of it is a carbon fiber filament inside a quartz envelope. Why? Because it responds quickly and holds its resistance steady. That means it handles thermal shock without flinching, and it doesn’t get fragile when you’re turning it on and off a lot. The R7s double-ended connector locks in tight—mechanically and electrically—even at high temps. So if you’re swapping out an old unit, this one slides in clean. This lamp shines wherever you need focused, clean heat—thermoforming, coating curing, plastic processing. Infrared delivers energy straight to the target, so cycle times shrink and you don’t end up wasting heat all over the place. Just keep in mind: it runs hot, with serious power density. Make sure the surrounding gear and mounting hardware can take the temperature. That way your whole system stays solid, shift after shift.