Introduction
We built this infrared drying lamp to slide right into your KTK oval screen printing machine—no fuss, no drama. The whole point? A true one-to-one swap. It matches the original size, mounts the same way, and hits the same thermal profile. So when a lamp burns out, you just pop in a new one and keep moving. No re-engineering your whole line.
The Nitty-Gritty
On the floor, mismatched dryers equal downtime. That’s why this lamp is built to match the KTK platform down to the last detail. It gives you heat you can count on, cycle after cycle. The voltage and wattage line up with the machine’s original setup, so you don’t have to rewire anything or mess with the electrical load. And the size stays exactly within the original footprint, so clearances around the screen frame and belt stay right where they should be.
What It’s Made Of
At the heart of it is shortwave infrared tech. It responds fast—when the lamp fires, the heat hits hard. When the machine idles, it stops on a dime. The quartz tube can handle the whiplash of constant heating and cooling without cracking. Inside, a halogen gas fill keeps the filament steady, even with all that on/off cycling. The outer coating is tuned to focus the IR right onto the substrate, so the heat goes where it’s needed—not wasted on the machine frame. And for the install? We use an R7s connector, so it wires up just like the original. No adapters. No rework.
What It Means for You
In a KTK oval press, this setup is all about control and keeping things running. The lamp hits operating temperature fast, so the dryer keeps pace with the press without lagging behind. It packs a lot of heat into a small space, which helps you cure thick ink deposits more quickly. Here’s the reality check, though: that kind of power density means your machine’s cooling and ventilation need to be up to spec. If airflow gets restricted, the lamp and nearby electronics will run hotter than they should. But as long as the airflow is right, you get a straightforward, drop-in replacement that keeps your drying profile consistent—one lamp after the next.